Counter Top Mix Tint Base |
 | $ 39.95 Call us for Availability
A Polymer-Modified / Low Water Countertop Mix
Printable Version | PRODUCT DESCRIPTION
LunaCrete® Counter Mix is a concentrate, high performance blend of high quality Portland Cement, modified Co- Polymers, Silica Sand, Water Reducers and Accelerants. It is a concentrated base mixture that is available in 2 versions.
Light Base, designed to work with our Color Pack system or Stain Base, which dries a light gray for chemical staining. It is designed for maximum strength, flexibility, adhesion, abrasion resistance, and freeze/thaw resistance. By having all of
the necessary ingredients pre-blended in a controlled environment, proper ratios of additives to cement and cement to pigments is consistent. Pre-blending promotes product consistency and color consistency. Because of the unusual characteristics of this formulation, it may be used for many different applications.
PRODUCT USES
LunaCrete® Counter Mix can be used to pre-cast or pour in place. The product can also be used for variety of concrete pre-casting such as tables, benches, fireplace hearths, stepping-stones and much more. Because the product is a concentrate, it allows contractors to be creative with specialty or colored aggregates without compromising the mix design. It can be finished by steel trowel, stamped, stained or polished. Applications can be from 1” thick up to 5” with great results. Available in 28 colors.
MIXING INSTRUCTIONS
In a clean concrete mixer (3 cubic foot or larger)
Measure 1 gallon of cool clean water
Add 2 Color Packs if desired
Add 1 pail of Counter Mix (add slowly while mixer is turning)
Add 40 Lbs of mason sand and let mix for approximately 3 minutes
Add 40 Lbs of pea rock (3/8 ” to 1/2 ” stone) and let mix for approximately 3 minutes
Add ½ to 1 gallon of cool clean water to create a plastic like consistency
Let mix on low-med. for 2-5 minutes or until thoroughly mixed.
Note: Do not over mix the product on high speeds, as this can entrain excessive air into the mix.
APPLICATION
See LunaCrete’s counter top application instructions.
COVERAGE
4 sq/ft at 2” Thick
6 sq/ft at 1 ½” Thick
TECHNICAL SPECIFICATIONS
Compressive Strength
28 Day Cure 6100 psi
Flexural Strength
28 Day Cure 985 psi
Impact Strength (IN-BS.)
28 Day Cure 16 Material Safety Data
for Counter Top Mix Tint Base | SUPPLIER IDENTIFICATION LunaCrete® 1154 N. US Highway 1 Ormond Beach, FL 32174 386-252-4243
Emergency Phone Number:
1-800-424-9300
Counter Top Mix Tint Base may be used to comply with OSHA's Hazard Communication Standard (HCS), 29 CFR 1910, 1200. Standard must be consulted for specific requirements.
The precise composition of this product is proprietary information. A more complete disclosure can be provided in the event of a medical emergency.
HMIS Hazardous Materials Identification System | HEALTH | 1 | FIRE | 0 | REACTIVITY | 0 | PROTECTION | E |
HMIS Number Codes
4 - Severe
3 - Serious
2 - Moderate
1 - Slight
0 - Minimal
HMIS Protective Equipment Codes
A - safety glasses
B - safety glasses and gloves
C - safety glasses, gloves and an apron
D - face shield, gloves and an apron
E - safety glasses, gloves and a dust respirator
F - safety glasses, gloves, apron and a dust respirator
G - safety glasses, a vapor respirator
H - splash goggles, gloves, apron and a vapor respirator
I - safety glasses, gloves and a dust/vapor respirator
J - splash goggles, gloves, apron and a dust/vapor respirator
K - airline hood or mask, gloves, full suit and boots
The Material Safety Data provided on this website is correct to the best of our knowledge, information and belief at the date of its publication. The information given is designed only as a guide for safe handling, use, processing, storage, transportation, disposal and release and is not to be considered as a warranty or quality specification. The information relates only to the specific material designated and may not be valid for such material used in combination with any other material or in any process, unless specified in the text.
Product will perform as indicated by product specification sheet. Any adulteration will negate LunaCrete liability. | HAZARDOUS INGREDIENTS/IDENTITY INFORMATION
COMPONENTS
Silica Crystaline Quartz
CAS # 144808-60-7
PER CENT 10%-30%
OSHA PEL 8H TWA 0.1 mg (Quartz/m3) (Respirable dust)
ACGIH TLV TWA (0.1 mg/m3) (Respirable dust)
Portland Cement
CAS # 6599-15-1
PER CENT 70%-90%
OSHA PEL 8H TWA 10mg/m3 (Total Dust)
ACGIH TLV 50 MPPCF
For industrial use only.
•Major = Over 25 % , Minor = Over 6. 25 % , Trace = Under 6 %, Residue = Unknown % residue possible
PHYSICAL/CHEMICAL CHARACTERISTICS
SPECIFIC GRAVITY (H2O = 1): 2.7
EVAPORATION RATE (Butyl Acetate = 1): None
MATERIAL V.O.C.: None
APPEARANCE & ODOR: Gray or Colored Finely Ground, Odorless
SOLUBILITY IN WATER: Soluble
% VOLATILE BY VOLUME: 0
FIRE & EXPLOSION HAZARD DATA
FLASH POINT: N/A
FLAMMABLE LIMITS IN AIR BY VOLUME: LOWER: N/A UPPER: N/A
EXTINGUISHING MEDIA: Non combustible. Use extinguishing method suitable for surroundings. NoFire or Explosion Hazard.
SPECIAL FIREFIGHTING PROCEDURES: Wear self-contained breathing apparatus with full face-piece, operated in pressure demand or other positive pressure mode. Wear full body protective clothing.
UNUSUAL FIRE & EXPLOSION HAZARDS:
Non combustible
REACTIVITY DATA
STABILITY: STABLE
CONDITIONS TO AVOID: Dusting conditions
INCOMPATIBILITY (CONDITIONS OR MATERIALS TO AVOID):
Avoid contact with strong alkalies or strong acids
HAZARDOUS DECOMPOSITON OR BYPRODUCTS: None known
HAZARDOUS POLYMERIZATION: WILL NOT OCCUR
HEALTH HAZARD DATA
A) HEALTH HAZARDS
INHALATION HEALTH RISKS AND SYMPTOMS OF EXPOSURE
Inhalation may cause irritation of respiratory tract and could promote coughing, dizziness and headache.
EYE CONTACT HEALTH RISKS AND SYMPTOMS OF EXPOSURE
Eye contact: Direct contact irritates slightly with redness and swelling.
SKIN ABSORPTION HEALTH RISKS AND SYMPTOMS OF EXPOSURE
Prolonged exposure can dry and defat skin causing cracks, irritation and dermatitis
INGESTION HEALTH RISKS AND SYMPTOMS OF EXPOSURE
Ingestion: Can cause gastrointestinal irritation.
CARCINOGENICITY:
NTP? NO IARC MONOGRAPHS? NO OSHA REGULATED ? NO
MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE: Dermatitis, respiratory tract irritation.
B) EMERGENCY AND FIRST AID PROCEDURES
INGESTION:
No harmful affects expected. If appreciable quantities are swallowed, call poison control center or physician. Do not leave victim unattended.
INHALATION:
If respiratory irritation or distress occurs, remove victim to fresh air. Seek medical attention if respiratory irritation or distress continues.
SKIN ABSORPTION:
If contact to the skin, wash thoroughly with soap and water. Seek medical attention if irritation or distress continues.
EYE CONTACT:
If contact with eyes, hold eyes open and flush with a steady, gentle stream of water for at least 15 minutes. Seek medical attention if irritation or visual changes occur.
PRECAUTIONS FOR SAFE HANDLING & USE
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED
Sweep up material and remove to disposal container. Mop with mild detergents or cleaning solutions. Observe all relevant federal, state and local laws.
WASTE ISPOSAL METHOD
Normal waste disposal. Avoid slurry of material may plug drains. Obey relevant laws.
PRECAUTIONS TO BE TAKEN IN HANDLING & STORING
Handling: Use a dustless system for storage and clean up if possible (Vacuum – Floor cleaner).
Wear gloves, eye protection and wear approved respirator. Wash hands before eating , drinking, using tobacco, applying cosmetics or using toilet.
Storage: do not store, use and/or consume foods, beverages, tobacco products or cosmetics in areas where this material is stored
OTHER PRECAUTIONS Practice Good Housekeeping, any food, drink or chewing product should be protected from the dust. Protect skin from prolonged contact with wet cement. Precaution must be taken because cement burns occur with little warning – Little heat is sensed.
Before using any LunaCrete products, read the label thoroughly.
CONTROL MEASURES
RESPIRATORY PROTECTION
Dust mask recommended- NIOSH or OSHA approved Standard #1910.134.
VENTILLATION
Use local exhaust ventilation to control emissions at its source, preventing dispersion of it in the general work area.
PROTECTIVE GLOVES
Gloves may be worn for protection if skin is sensitive. (latex, neoprene, nitrile rubber)
EYE PROTECTION
Use safety glasses, goggles or face-shields for eye protection.
OTHER PROTECTIVE CLOTHING OR EQUIPMENT
NONE
WORK/HYGIENE PRACTICES
Avoid breathing dust. Wash hands thoroughly after handling and keep containers closed. |
For additional information contact: LunaCrete® LunaCrete, LLC 1154 N. US Highway 1 Ormond Beach, FL 32174 (866) 386-9122 - Toll Free (386) 252-4243 - Office (386) 506-8924 - Fax www.LunaCrete.com |  | If you have already purchased access to an online video, |
|
|
Professional Products |
Online Catalog |
Complete DVD Set |
|
